The spindle plays an irreplaceable role in the shredder device, any shredder equipments in use after a period of time, will not the same degree of spindle in the shift or the occurrence of space and even bending, bending will not only reduce the bearing and spindle using his, also can give you the usual work pieces bring a lot of trouble, not accurate or spindle may cause bending blades cutting each other and of the blade wear, not natural, seriously affecting the blade using his, will also affect the processing scale of the material, the shredder hypothesis is the selection method of reducer is used, it will cause the reducer using his cut, selection of belt drive will be very simple jump, then reduce the life by using triangle belt, so we have to keep the spindle shredder calibration, Avoid these unnecessary troubles.
The correction of the main shaft of the shredder requires the press, the four jaw chuck, the base support frame and so on. The main method of correcting the spindle is as follows:
1.Use the press to correct the fourth segments of the spindle, mainly use the four jaw chuck to clamp the fifth section, select the base support structure support third segments, and find the fourth section base;
2.Then hit the base eye, and then with the thimble to withstand, dismantle the base frame, the first paragraph of the fine car, the third paragraph, the rough car vacancy some;
3.Is the first use of the final machining spindle, four claw chuck top section, the base frame supporting structure for supporting fifth sections, fourth sections of base alignment. Hit the base, and then use the thimble to withstand, dismantle the base frame, fine car fifth sections, rough car vacancy some.
The correction method of all spindle is that, if you have any unclear local in operation, you can contact the Kowloon factory technical department at any time, and make the most accurate correction.
