Plastic shredder installation and debugging, normally we will delivery to the client with a drawing of the foundation, foundation construction drawing design, we are firmly installed in the machine specially designed on the basis of, in order to better withstand the worker generated by force, can be placed under the chassis sleeper wood to make the whole machine and sleeper wood joint, and leave out the position. Testing plastic shredder load test, the idle running test, on the basis of good will to carry on the load running test, load test time shall not be less than 8 hours continuous operation, determination of plastic shredder actual LiaoDu and production is in accordance with the requirements, and ensure the bearing temperature rise shall not exceed 35 degrees, shredder work should be smooth, there should be no more severe vibration, various fasteners should be reliable. Plastic shredder all lubricating points must be full of lubrication oil, seal should be good, no leakage phenomenon, such as when working found production or particle size does not conform to the requirements, the available activities adjustment bolt to adjust the device after the end, if discover current fluctuation during operation is not stable, should check the feed particle size is in accordance with the requirements, the load test can be put into production after normal use. The plastic shredder USES the friction of the rolls to crush the material into the broken area, which can be subjected to crushing or splitting and crusherry. When used for coarse crushing or needing to increase the crushing ratio, the plastic shredder usually makes teeth or grooves on the rolls to increase the splitting effect. There are any questions in the use of plastic shredder. Please feel free to contact us.
